hdxr750
Single-Sixer
I ask on the Smithing section also. I need a screw for the ERH that fits the OM, any one have one? Respond to this post or [email protected], 3046394624. Thanks, Randy
ERH screw
- Thread starter hdxr750
- Start date
Bob Wright
Hawkeye
The ejector rod housing screw is the same for old models and for the New Models. First check you barrel to determine the correct screw ~ does it thread into a tapped hole in the barrel, or is there a stud for the ejector rod housing?
Brownell's has both types.
Bob Wright
Brownell's has both types.
Bob Wright
Hondo44
Hawkeye
Randy,
This the kind of small part that Ruger will send you for free, just call them
336-949-5200)
As BOB posted above, old and new models are the same but there's two sizes:
Old model centerfire guns have a barrel stud as do early New Models and use a 1/4" diameter cap screw, 6x40 thread.
All Single Sixes old and new and later new model centerfire guns w/o barrel stud use a cap screw .217” in diameter, 8x36 thread.
This the kind of small part that Ruger will send you for free, just call them
336-949-5200)As BOB posted above, old and new models are the same but there's two sizes:
Old model centerfire guns have a barrel stud as do early New Models and use a 1/4" diameter cap screw, 6x40 thread.
All Single Sixes old and new and later new model centerfire guns w/o barrel stud use a cap screw .217” in diameter, 8x36 thread.
