Got my Gun Guide from IOWEGAN and a master-spring kit from Brownell's. I followed directions: took it apart and sanded, buffed, polished, and took 0.018" off the top hammer step to prevent light firing-pin hits. Changed out the stock 14# spring for a Brownell's 12#. After reassembly, my single-action pull went from a nasty 5.5# pull to a clean and crisp 4.25# break.
My stock firing pin measured a solid 0.055" before the top hammer step stock removal, so I expect that should be fine. I haven't done a lot of this internal work, but the Gun Guide made it pretty simple. And I appreciate it, Mr. IOWEGAN.
Now I gotta get to the range.
Sonnytoo
Here's the link:
http://rugerforum.net/miscellaneous/188 ... guide.html
My stock firing pin measured a solid 0.055" before the top hammer step stock removal, so I expect that should be fine. I haven't done a lot of this internal work, but the Gun Guide made it pretty simple. And I appreciate it, Mr. IOWEGAN.
Now I gotta get to the range.
Sonnytoo
Here's the link:
http://rugerforum.net/miscellaneous/188 ... guide.html