Acorn
Buckeye
I want to replace the springs in my SP101s. The seam between the trigger guard assembly and the frame is nearly invisible. When I reassemble will it still fit as nice?
Interesting , thanks for the education !NikA said:I would say it's possible to get it to fit as nice, but in my experience it will be difficult. Be prepare to spend some time with a non-marring object "adjusting" it to get it back into place.
PS: the reason it fits so well from the factory is that it's finished after assembly.
Easily too, I just did the main hammer spring on my SP101 and it was a quick swap out. Few minutes effort and a better trigger pull.robmkivseries70 said:The main spring can be replaced with out removing the trigger assembly.
57springer said:Interesting , thanks for the education !NikA said:I would say it's possible to get it to fit as nice, but in my experience it will be difficult. Be prepare to spend some time with a non-marring object "adjusting" it to get it back into place.
PS: the reason it fits so well from the factory is that it's finished after assembly.