Recent content by JamesLoren

What part of california are you from? any chance LA area?

I have found the heavier bullets seem to shoot best in my old model single six. The winchester dyna point 45 grain, and the 50 grain federal load is also very accurate.

I to, would be interested to find out if the NEGC peep sight would work with the factory front sight?

Hi, I prepared some cases a while back, primed them ,and set them aside. I can not remember if i used cci small pistol, Or small pistol magnum primers? Is there a way to tell the diferance between the two by just looking? thanks

Has anyone tried one on a 77/22, I have been tempted to try one, But i do not want to change the front sight?

I saw a post a while back from a forum member who said he did 10/22 trigger jobs, If any one recalls his name, Please post it! thanks.

Hi, My 77/22 mag, Is well built and very accurate, I would choose the ruger over the savage, The 77/22 is a good rifle

Brass is sold.

, SOLD to ruger 1nut , thank you

I will also throw in 90 pieces of unfired starline brass with the 3 die set, to sweeten the deal! $46 shipped

Like new ,redding 3 die carbide set with box, 32 H&R magnum $46 shipped

Thanks for all the great advice!!

Hi, what would be a good cutting oil for using on cutting steel?I am going to recrown a barrel, using a hand turned 12 flute cutter, The directions call for using a good oil, what do think would work the best? I am looking for some thing that i can find at a local hardware store, or lowes ?Thanks.

I have had to file the front sight slightly on 2 of mine to raise the impact!, Both shot a few inches low! with most loads.

HI, I am a fairly new reloader, So far i have loaded about 1500 rounds, All lead, All with a roll crimp, So ,when loading jacketed bullets, Do you use the expander plug, and flare the case mouth slightly, like with lead bullets? And what type of crimping practices are used with jacketed bullets...