Weapon Shield

Help Support Ruger Forum:

3leggeddog

Single-Sixer
Joined
Aug 3, 2009
Messages
267
Hello,I got a free sample with a needle dispenser on it . I put a little in the MAG for my Mark II , its so smooth now, just great. It did clean the barrel up really good on both my pistols! Anyone got a way that they like to put it on ??? Didn't someone say to use a "blow dryer"?? Thanks for your Ideals!
 

bullockdgmanor

Bearcat
Joined
Nov 8, 2009
Messages
33
I use Weapon Shield on my Mark III. When I clean after shooting, I'll run a couple of patches with a few drops of WS though the bore, then a dry patch. After I clean out the chamber with Hoppes, I'll put WS on a Q-tip and wipe the whole chamber. I put a small drop on each side of the bolt, where wear is evident, and cycle the bolt a few times (seems to make it move a lot more smoothly). Then I use a small piece of cotton rag with a little WS on it to wipe down the whole exterior (blued finish) and the mags.

No heat required (isn't it militec that needs heat?).

Dan
 

rmansu2

Single-Sixer
Joined
Sep 9, 2009
Messages
142
How does Weapon Shield perform on polymer and stainless like the KP95?

Who has this on their shelves?
Bass Pro, Cabela's, Academy, or would a local gun shop be a better place to look?
 

3leggeddog

Single-Sixer
Joined
Aug 3, 2009
Messages
267
rmansu2":19rvwl0x said:
How does Weapon Shield perform on polymer and stainless like the KP95?

Who has this on their shelves?
Bass Pro, Cabela's, Academy, or would a local gun shop be a better place to look?

I went to their web sight and got mind, it hasnt hurt my SR9 any! Its real handy to get a small half drop of oil in them hard to get at places. I put a thin film on my Mark II bolt, 10 days later I shot 80-100 rds and it was still there! Try the smalll one with the needel dispencer on the end, im thinking I may be able to refill it with what ever I want if need be.
 
Top