Trigger Return Spring Question

[Bountyhunter]

I'm going to fit a brass grip frame to my NM BH, and the brass grip frame has a block with a hole thru it pinned in where the spring would go. I believe that it is for an OM plunger type return? Should I pop the pin and remove the block to install a NH style set up, or do I need to look for the plunger type parts? I'm not sure the plunger type return will work?

 

[Bountyhunter]

Well I figured it out. I popped out the pin and block and put in the NM style spring and spring pin.

Thanks for all the help. :lol: :lol: :lol: :lol: :lol:


I can't budge the pin holding the spring legs in place though. Does it just push out? :?

 

[Bountyhunter]

Figured that out too. I ordered a new one. :roll: :lol: :lol:

 

[flatgate]

There 'ya go, getting through the Homeboy School of Gunsmithing!!!!

Been there, done that!

flatgate

 

[Bountyhunter]

Gotta learn it somehow, Flatgate. I see all the stuff you do to your guns and figure you started somewhere too.