SR45 question

[frontstuffers]

Not sure if should go here or in Ruger smithing......anyway, was wondering if anyone here has installed a "Tactical Ghost Trigger Bar" in their SR45? I was wondering if it is worth it or not.

Thanks,

Bill

 

[Laserbait]

I have not seen one for the SR45 before. Who makes one?

 

[frontstuffers]

The one I found was on ebay and says "Ghost Inc." I think that they are the ones who make all of the others as well.

 

[KYhunter]

Yes. I have installed the transfer bar to reduce the trigger pull. It had limited impact but was able to measure a reduction from approximately 6 to 6.5 down to about 5 1/2 or so at best. Some improvement but not what I hoped for. Was wanting to get to 3 to 4 lbs. hope this is helpful. KY

 

[frontstuffers]

Yes, very much so. This is the type of info I was looking for. Not wanting to drop trigger pull as much as improving performance. Thanks for the reply.

 

[KYhunter]

Glad to help. Just a question when you say improve performance , are you by any chance having lite primer strikes. This is one of the more significant problems I have had and had to contact Ruger for a new spring that did help a bit. KYHUNTER