Got these Badgers last week. Very nice feel, except for a slight mismatch of the two halves of the grip. It may be I can just uninstall and reinstall with an eye toward lining the halves up better. Otherwise, a little sanding will resolve. These are much more concealable than the Hogues I was using.
Willie,
When you installed the Badger Grips, did you make use of the "cross pin" that comes with the original grips? I'm not sure what the proper name of this pin is, but it is the one that, after sliding on the factory grips, slides left-to-right through a hole in the grips and keeps the grips from slipping down.
When I first got my Badger Boot Grips, I installed them without using this pin and I too couldn't get the grip halves to perfectly match up. But, when the pin is used, they match up perfectly on my SP.
Regards,
Jon