Plain Old Bill
Bearcat
I'm stymied....I have an older Single-Six heirloom. Recently, I took the base pin out and gave the cylinder and frame a thorough cleaning. When I tried to place the cylinder back in, I just couldn't get the back of the cylinder to align to put the pin in. Ended up cutting off the spring-loaded pin at the end of the base pin, Ruger is sending another....BUT even trying to place the cylinder in without the pin just to align it, it's a no go- tried with the hammer down, also at first notch, gate always open. Just can't seem to get the rear of the cylinder into alignment.
Anyone know what I'm doing wrong? Thanks in advance for your help- POB
Anyone know what I'm doing wrong? Thanks in advance for your help- POB