I just picked up a new SR1911 10mm and at first didn't like the performance. After a breakdown/inspection/cleaning/lubing it was out to the back porch to let loose a few rounds. The first mag had failure to feed with the round hung up half way into the chamber, when I pulled the slide back to clear it three rounds flew straight up out of the gun. Second mag just needed a bump on the back of the slide to fully seat one round, after that I fired about six magazines full with no problems. I didn't have a target set up so I was just plinking at rocks and sticks out to 65 yds and it shows promise in the accuracy department. I changed out the black grips (prefer the double diamond wood) for some decent wood grips. From the Factory the trigger broke at a 4 lb pull over a ten pull average with a moderate amount of take up with a decently crisp break and some over travel. The trigger does have an over travel adjustment screw so that can be taken care of, overall it's a pretty decent trigger for a production gun. Hopefully I can get some range time this week and can take my Delta Elite and SR 1911 10 mm both and compare them.