Old model super Blackhawk 44 mag barrel length question

greystonedog

Bearcat
Joined
Dec 27, 2014
Messages
95
City & State/Province
cumming GA
Did they make one with a 4 5/8 inch bbl.? This one is on a local trader site. It has unfluted cylinder and round trigger guard. Thanks
 
Not factory.
I bought one similar several years ago. Cut bbl,,, factory made (later installed,) brass g/f, & reblued. It's a shooter for sure!
 
I disagree. I have the exact SBH as described in the original post. I guarantee you it is factory to the front sight. Mfg sometime around 2013.

Regards
 
As an Amazon Associate we earn from qualifying purchases. Product prices and availability are accurate as of the date/time indicated and are subject to change.
greystonedog said:
Did they make one with a 4 5/8 inch bbl.? This one is on a local trader site. It has unfluted cylinder and round trigger guard. Thanks

You looking at the "Rare Hard to Find" one on GA Outdoor?? I like it but at $700 it is a bit steep for a "parts gun"...but I suppose if you took it to a gunsmith and had the barrel shortend and with the cost of the 7-1/2 in good shape, you could be into it for that much...it looks like it is in pretty fair shape. (the grip frame ears are a tad tall where they meet the main frame.)

I'm hoping if I sit on the fence long enough, someone else will buy it... 8)
 
As to Three Screw Super Blackhawks, I believe there were some 6 1/2" barreled models made. But the cataloged models were all 7 1/2" in length.

The marks of the Super Blackhawk of the day were: Non fluted cylinder, 7 1/2" barrel, ribbed rear sight, Dragoon style grip frame and wide grooved trigger with the low, wide hammer spur. Also, a deluxe blue finish.

Current New Model Blackhawks exhibit the low wide hammer spur as the only mark of a Super. Grip frame, of steel, either Dragoon style or Blackhawk style, barrels from here to yonder, fluted or non fluted cylinders, blue or stainless; anything Ruger dreams up.

Bob Wright
 
Back
Top