Brass gripframes and old models

[SteelShooter]

Do the old Ruger brass grip frames fit all the old 3 Screw Rugers?

Have a couple of single six flat gates and one has a dinged up grip frame. Would like to eventually replace it with one of the brass grip frames if possible, but wanted to see if it would fit, before took the plunge to look for one.

Know they fit the old 3 Screw Blackhawks, but wasn't certain if the grip frame and frame fit were the same for the singel sixes.

Thanks!

 

[rugerguy]

yes, they will fit the Single Six, though they look a bit 'odd' with that big ,long frame and the squared back trigger guard...only seen a couple in all these years...the guys who had them, loved them, and as long as the frame you get has been already "fitted" and came off a gun somewhere down the road, you may have to "finish fit" to blend in , match the edges and all,not that hard to do ,and most you do find /see. came off of guns//yes, they are a bit "pricy" have been in the mid $300 range,and the wide trigger ,box etc, drives up the cost /price/value of the "package"........good luck

 

[SteelShooter]

RugerGuy

Much appreciated!