dixie884
Blackhawk
Come on Lipseys, give us a break.........
dixie884 said:Come on Lipseys, give us a break.........
CraigC said:I'd rather see Ruger legitimize the .41Spl. It wouldn't have to be limited to powder puff factory loads like the .44Spl. It could be rated up to 1200fps.
Robb Barnes said:I have a feeling that the 41 mid frame and 41 Vaquero along with 41 Special are going to stay the result of the custom route. Luckily it doesn't cost that much to do either conversion. There is just not enough of us 41 freaks to get a manufacturer to foot the expense of the initial outlay for such changes. That said, some recent playing with both mid framed 41 Specials and the TLa guns has led to some neat findings. Lets just say a 41 Special round loaded with a 265 grain LFN cast bullet is a very effective combo in both a mid framed 41 Special or a full sized TLA 41 mag.
Robb Barnes said:I have a feeling that the 41 mid frame and 41 Vaquero along with 41 Special are going to stay the result of the custom route. Luckily it doesn't cost that much to do either conversion. There is just not enough of us 41 freaks to get a manufacturer to foot the expense of the initial outlay for such changes.
Hondo44 said:Perhaps the easiest and least expensive way to make a .41 Spl GP100 would be to ream the 10mm cylinder for .41 Spl cartridges and load with 10mm (.400") bullets; which is mostly only hand loaded anyway.
The same with the .40 S&W and 10mm Blackhawks.
5of7 said:Hondo44 said:Perhaps the easiest and least expensive way to make a .41 Spl GP100 would be to ream the 10mm cylinder for .41 Spl cartridges and load with 10mm (.400") bullets; which is mostly only hand loaded anyway.
The same with the .40 S&W and 10mm Blackhawks.
Sounds easy, but I am not sure that the bullets would seat snugly in a .41 Sp. case being .010" smaller than the case was designed for...no?