Aggie01
Buckeye
SOLD
Old Model Super Blackhawk in .44 Mag w/ 4&5/8" barrel and Bisley grip frame.
Was planning on getting a Clements OM Bisley trigger for it and then finishing it up.
Brass adaptor installed with a pin (not permanent) for the OM trigger spring/plunger arrangement.
Bisley grip frame is not final fitted. Plenty of meat to finish it out - fit is very close near the lettering and SN. You will need to take some off the ears on top, off the rear of cylinder frame on the LH (side marked w caliber) and some off the rear of the grip frame on the RH side 9(side marked w SN).
The Barreled cylinder frame came to me with the 4& 5/8" barrel with the Sturm, Ruger & Co., INC address, and it not a ruger factory crown.
Quite a bit of honest wear, obviously the grip frame and grips are a different vintage than the rest of the gun.
Looks like it was refinished in the past, (probably when the barrel was cut down) and the "hawk" in blackhawk is gone.
Power Custom OM Bisley hammer & Ruger grooved wide SBH trigger. Hammer is cold blued (oxpho blue) to prevent rust.
I believe $800 shipped is less than the sum of the parts, but that's what I am going to ask.
Old Model Super Blackhawk in .44 Mag w/ 4&5/8" barrel and Bisley grip frame.
Was planning on getting a Clements OM Bisley trigger for it and then finishing it up.
Brass adaptor installed with a pin (not permanent) for the OM trigger spring/plunger arrangement.
Bisley grip frame is not final fitted. Plenty of meat to finish it out - fit is very close near the lettering and SN. You will need to take some off the ears on top, off the rear of cylinder frame on the LH (side marked w caliber) and some off the rear of the grip frame on the RH side 9(side marked w SN).
The Barreled cylinder frame came to me with the 4& 5/8" barrel with the Sturm, Ruger & Co., INC address, and it not a ruger factory crown.
Quite a bit of honest wear, obviously the grip frame and grips are a different vintage than the rest of the gun.
Looks like it was refinished in the past, (probably when the barrel was cut down) and the "hawk" in blackhawk is gone.
Power Custom OM Bisley hammer & Ruger grooved wide SBH trigger. Hammer is cold blued (oxpho blue) to prevent rust.
I believe $800 shipped is less than the sum of the parts, but that's what I am going to ask.
