I know that there are some mechanists around that manufacture cylinders for Blackhawks but does anyone manufacture cylinders for a new model Bearcat?
Question about cylinders
- Thread starter Fox Mike
- Start date
Help Support Ruger Forum:
Hondo44
Hawkeye
Not that I'm aware. Have you googled for one?
There's little difficulty finding Bearcat cyls, therefore may not be a sufficient market to produce them.
What's your plan for one?
There's little difficulty finding Bearcat cyls, therefore may not be a sufficient market to produce them.
What's your plan for one?
I can find a gazillion OLD model cylinders however I need a new model.Hondo44 said:
Hondo44
Hawkeye
Keep searching, everything shows up eventually.
Set up a search in Ebay and Gunbroker, and you'll get all new listings each morning in an email. That way you'll get first crack at them.
When searching, overall length is the important issue; too short, let it go, same length as yours or slightly longer, buy it!
Set up a search in Ebay and Gunbroker, and you'll get all new listings each morning in an email. That way you'll get first crack at them.
When searching, overall length is the important issue; too short, let it go, same length as yours or slightly longer, buy it!
Muley Gil
Blackhawk
What do plan to do with this cylinder? I bought a stainless NM Bearcat cylinder off of the forum. I re-chambered it to .22 Magnum.
I am looking for a new model blued cylinder to chamber to .22WMR and used in my 6" model.Muley Gil said:
Hondo44
Hawkeye
Yes, so you need the slightly longer new model cyl.
Which is what I said I my original post. new model.Hondo44 said:
