MKII help needed to put back together

[clint_lnl]

I have had it apart for cleaning years ago and back together, never any trouble. but this time was jamming and this time found the pin for the sear had backed out. so stripped it down and the hammer and bolt stop and safety fell out. put it back the way I think it shoud be but its not working. is there a web site I can see how to get it back togther? Or anyone near Charlotte or Concord ,NC that can help or a gunsmith. Thanks again Clint

 

[contender]

Welcome to the forum!!!
I'm not too far,, or too close to ya,, if you need my help. I've reassembeled a few in my time. I'd be glad to help,,,!
(Too bad ya didn't post this a few days ago. I was in Concord all day Sun at BASS Pro.)

 

[berettapistols]

Here's a webpage that should help you out..
http://www.1bad69.com/ruger/internals.htm
Click any picture to see it LARGE..
Good Luck, Hopefully you didn't lose the safety spring & detent, you should be good to go..
Let us know how it turned out..
Gary

 

[Baldy]

Here's another good place with photos of everything you need to do. Click on the photos and they will enlarge. Good luck.

http://guntalk-online.com/service.html

 

[clint_lnl]

Thank you all, its back together and working fine, thanks again for the offer of help and the web sites. that was just what I needed. with it coming apart I was unsure and now I am. and that was a good point about the safety spring & detent, it did come out and back together ok.
thanks Clint

 

[berettapistols]

Good To Here Clint..