Sharps40
Buckeye
- Joined
- Apr 15, 2014
- Messages
- 1,018
Great progress, all together but the transfer bar and hand and it all works, coil spring conversion completed, one piece grip keyholed for coil spring conversion and found a nice place to hook the new model trigger spring feet on....I used the bear cat locking bolt plunger and spring because though the same diameter, they are shorter and work much better with the converted flat spring uberti trigger guard. Rough, gritty and clunky right now but I'm all in but for the finesse work.
The photos show the keyhole in the grip making room for the coil main spring and its foot. The legs of the trigger spring pulled up and over the center of the one piece grip assembly in order to tension the trigger. The rough but assembled grip and grip frame with the hammer at the ready and the locking bolt fully functional/locking the cylinder in preparation for firing.
The photos show the keyhole in the grip making room for the coil main spring and its foot. The legs of the trigger spring pulled up and over the center of the one piece grip assembly in order to tension the trigger. The rough but assembled grip and grip frame with the hammer at the ready and the locking bolt fully functional/locking the cylinder in preparation for firing.