Just picked up a really nice 3" GP100. Did a light polish on the trigger. Very nice trigger, except for a bit of hesitation at the end of the trigger return. Reinstalled the factory, trigger return spring, but no difference. I tried pinning down where the hitch is, but can't find it. Any ideas?
GP 100 trigger return gritty
- Thread starter eddieb
- Start date
Help Support Ruger Forum:
glockman99
Single-Sixer
Did you polish inside the frame where the trigger, hammer, & transfer bar moves?
GP100man
Buckeye
the trigger return well may need polishing with a 13/64 drill bit .
but the return problem sounds as if the plunger (arrow shaped peice) may have a weak spring pushing on it (pawl plunger spring).or the cyl latch spring weak.
also there may be a ruff surface on the square frnt on the latch.
If this is good the plunger may have been over polished
but the return problem sounds as if the plunger (arrow shaped peice) may have a weak spring pushing on it (pawl plunger spring).or the cyl latch spring weak.
also there may be a ruff surface on the square frnt on the latch.
If this is good the plunger may have been over polished
