Joe S.
Hunter
Got my Single Seven back and this was listed under the work done to it.
What is this?
What is this?
"Chamfer the barrel"
- Thread starter Joe S.
- Start date
bcgunworks
Single-Sixer
I wonder if they mean crown?
protoolman
Service-Sixer
Or recut the forcing cone.
mohavesam
Hawkeye
back from where?
OP
Joe S.
Hunter
Sent it to Ruger for a base pin issue.
Hondo44
Hawkeye
Hi Joe,
A barrel can only be chamfered at the muzzle or at the throat. So apparently one or both had a very sharp lip either on the outside diameter or bore. Can you see any shiny edges at those locations where some chamfering was done?
A barrel can only be chamfered at the muzzle or at the throat. So apparently one or both had a very sharp lip either on the outside diameter or bore. Can you see any shiny edges at those locations where some chamfering was done?
OP
Joe S.
Hunter
Jim
It isnt obvious at either end...
It isnt obvious at either end...
Hondo44
Hawkeye
If there's a chamfer now, it may just have not had any before.
Similar threads
