The Stainless Security six I'm looking at getting; the seller measured the BC gap and said the thickess he could get a feeler gauge between the barrel and cylinder was 0.0015
Pushing the cylinder back and pushing it forward it Did not change. I have been told this is a pretty tight BC gap. Do any of you know a Gubsmith near central Florida who could correct this before it would become an issue and the possible cost to do so? I would already be into the gun for around $650.00 or so. As it is now, with the cost of the the gun plus the shipping and repair cost should I pass on it with that BC gap?
- Austin
Pushing the cylinder back and pushing it forward it Did not change. I have been told this is a pretty tight BC gap. Do any of you know a Gubsmith near central Florida who could correct this before it would become an issue and the possible cost to do so? I would already be into the gun for around $650.00 or so. As it is now, with the cost of the the gun plus the shipping and repair cost should I pass on it with that BC gap?
- Austin