Recent content by calvin

Thanks for all the answers & info. It is a great help. Cal

Thanks for the info, Same question for the single ten? Cal

Greetings all, Would anyone happen to know if the "charge holes" on the .22LR single seven revolver line up with the ejector rod for loading and unloading as the cylinder "clicks" into place. Thanks, Cal.

Hello fellow members, I have a question concerning the grip frame of my Super Blackhawk with the square trigger guard. I purchased a Pachmayr presentation grip for this pistol but it will not "wrap" around the grip frame and seems too narrow to completely close on the frame. The retaining screw...

Perhaps I could add something to this subject. IN the late 50's I was station at a U. S. Army base in Eritera (which was at that time, a providence of Ethiopia). I, along with everial members of my unit purchased Ruger Blackhawks in various barrell lengths from the base Post Exchange. These...

Thanks folks, I appreicate the answers and it helps a lot. Cal

Hello everyone, I saw this question on another forum and not being sure of the difference myself, I would like to ask if the dovetail cut for the rear sight is the same on the MKI and the MKII. Thanks, Calvin. -------------------------------------------------------------------------- Mk II vs...

Good morning and thanks for the help. I called Randch Products and ordered one of their extended releases for my pistol Saturday morning. It will be here in a couple of days and I'm looking forward to installing it. Cal

Hi there once more, Thanks to all and does anyone have a preference as to which extended release is the easiest to install? Cal

Hi there "boles", This answer may be a little late but I have just seen you question. I have an older Ruger MKI without the receiver being drilled and tapped for a rail. I purchased a Weigand "no gunsmithing rail" and it mounted on my pistol without any problem and it is as solid as a rock...

Good morning, Has anyone fitted an extended magazinerelease on a ruger (MKI) standard auto? I am considering installing one on my MKI, but I would like to hear from someone that has done this, and what thir experence has been. Thanks, Cal.

Hello everyone, I finely ordered one of the "no gunsmith" rails from Weigand for my Ruger MKI and installed it this past weekend. It was as advertised and went onto the pistol very easy. once installed' it was rock solid without any "play" or movement detected. I installed a Bushnell red-dot...

Thanks for the info. Cal

Hello all, Has anyone installed one of the WEIGAND "no gunsmithing" scope rail on a MKI that is not drilled and tapped for a rail? As I understand it, the rail is designed to be secured by a spacer installed in the rear sight dovetail. thanks, Cal.

Thanks fellows, I appreciate the speedy reply and info. Cal