bocash3
Bearcat
Howdy.
Was cleaning the about 2009 built #1 in .223 today and messed with the two trigger screws a bit.
Screwed the forward screw in until the trigger would not pull, then backed out enough until the hammer
was dropping, then turned another half turn or a bit more.
Then I noticed after cleaning that the Safety would not go ON!
Worked lever several times. Dry fired several times. Turned both screws both up and down then re-set
the forward screw as above. STILL No Safety!!
This is one I can't figure out.......................... so did something come disconnected inside?
Thanks to all in advance, Bo in western NC
Was cleaning the about 2009 built #1 in .223 today and messed with the two trigger screws a bit.
Screwed the forward screw in until the trigger would not pull, then backed out enough until the hammer
was dropping, then turned another half turn or a bit more.
Then I noticed after cleaning that the Safety would not go ON!
Worked lever several times. Dry fired several times. Turned both screws both up and down then re-set
the forward screw as above. STILL No Safety!!
This is one I can't figure out.......................... so did something come disconnected inside?
Thanks to all in advance, Bo in western NC
Last edited: