TINCANBANDIT
Single-Sixer
- Joined
- Jan 3, 2014
- Messages
- 216
I just started another 10/22 project, this is my third one in a series of projects that mostly involve custom stocks modified from Ruger factory wood stocks
http://tincanbandit.blogspot.com/2016/03/1022-projects.html
This one will be mimicking the gun below (from the rimfire central forum)
My plan is to:
* Strip and polish a factory 10/22 Charger receiver and add a KIDD rear tang
* Strip, polish and perform trigger/action job on a factory 10/22 aluminum trigger assembly
* Perform some accurizing mods to a factory bolt then polish and jewel it
* Polish a factory stainless barrel
* Add a 50mm scope
* Build a custom thumb-hole stock using a factory beech wood stock as the basis
and do all of this on a $400 +/- budget
Here is my 1st blog post, I would post the pictures here individually, but I am lazy and that takes a lot of time
http://tincanbandit.blogspot.com/2016/07/the-1022-target-rifle-project-part-1.html
http://tincanbandit.blogspot.com/2016/03/1022-projects.html
This one will be mimicking the gun below (from the rimfire central forum)
My plan is to:
* Strip and polish a factory 10/22 Charger receiver and add a KIDD rear tang
* Strip, polish and perform trigger/action job on a factory 10/22 aluminum trigger assembly
* Perform some accurizing mods to a factory bolt then polish and jewel it
* Polish a factory stainless barrel
* Add a 50mm scope
* Build a custom thumb-hole stock using a factory beech wood stock as the basis
and do all of this on a $400 +/- budget
Here is my 1st blog post, I would post the pictures here individually, but I am lazy and that takes a lot of time
http://tincanbandit.blogspot.com/2016/07/the-1022-target-rifle-project-part-1.html