Single Ten finicky about ammo

3spur

Bearcat
Joined
Apr 2, 2012
Messages
20
I have a Single Ten that was finicky with some Winchester .22LR hollow points, they don't go in the cylinder, is this common??? I'm new to guns.
Thanks
 
Did this occur after you had shot several of them? The reason I ask is I have shot some winchester 22s in my single six and they were very dirty. After a couple hundred rounds, they started to seat really difficultly. A good cleaning afterwords and they basically dropped into the cylinder.
 
No, right at the get go they didn't fit, they did however fit in my husband's rough rider and the 10/22, just not the single ten, remington .22's fit just perfect, wondering if it has something to do with it holding ten rounds instead of six, maybe the cylinder is different somehow
 
Your gun is fine, it's the ammo. Just try some different types and eventually you'll find what's the most accurate load for your particular gun too.
 
MOUNTAIN WILLIAM said:
Your gun is fine, it's the ammo. Just try some different types and eventually you'll find what's the most accurate load for your particular gun too.

I'm not sure about that. All brands of .22 ammo should be the same diameter, so this leads me to think the cylinder wasn't reamed properly.
 
If it handled Remington ammo just fine the revolver is most likely ok, it's possible that this lot of Winchester rimfire ammo was out of spec.
Have you ever had any problems with 9mm Winchester ammo from Wally World? I have.
 
MOUNTAIN WILLIAM said:
If it handled Remington ammo just fine the revolver is most likely ok, it's possible that this lot of Winchester rimfire ammo was out of spec.
Have you ever had any problems with 9mm Winchester ammo from Wally World? I have.

Oops - I missed the part where it handled the Remington ammo fine. That's what I get for not reading every word.
Yeah, it sounds like a bad box of Winchester ammo.
 
ndcowboy said:
All brands of .22 ammo should be the same diameter, so this leads me to think the cylinder wasn't reamed properly.
True to a point but many are 0.001 +/- from others. A case in point is Thunderbolts. They will NOT fit any revolver I own. Work fine in the 10-22.
 
I have had a lot of trouble with Winchester .22 ammo in semi-autos... Not yet had any 'fit' problems such as described in the OP with SA shooting, but the consistency with which I've had trouble with Win ammo has driven me to other brands.
 
Semi auto rifles tend to have oversize chambers to increase feeding reliability, and Rough riders are probably just sloppy. The Ruger chamber will be right and the ammo a bit oversize and some brands will be snug. It is not likely to be the gun if other brands work fine.
 

Latest posts

Back
Top