Sharp edges on P95 slide?

[Remington788]

I just got a P95 and find that where those serrations cross the cutout for the extractor there are some rather sharp edges. Sharp like the eye teeth on a puppy.

Anyone else notice this?
Is there a solution? I'm not sure if I want to file down the edges or not.

 

[roylt]

It is your gun so if you want to file it do it. I would maybe try a fine sand paper first before going right to a file though. I would also remove the extractor to keep it from getting any scratches etc. and maybe the decocker lever too.

 

[roylt]

I assume this gun is stainless. If it is blue you will need to cold blue it to make it look right again as well.

 

[Remington788]

It is your gun so if you want to file it do it. I would maybe try a fine sand paper first before going right to a file though. I would also remove the extractor to keep it from getting any scratches etc. and maybe the decocker lever too.

Yes, it is stainless.
That's a lot of things to take off. I am not all that comfortable disassembling it that far.

I think I will just work on building up the calluses on the finger that hits it.

 

[roylt]

Actually it is super easy to take those two items off. You pop the extractor off with a flat blade screw driver and then the decocker falls right out too. The extractor hold it in place.

Good luck either way.