Ruger 10/22 Build

[T.A. WORKMAN]

Almost done with this first build, just need to bed it and tune her in. Let me say up front that its almost impossible to only build one!! I've got three more going now! :twisted:

Stock, is discontinued Predator in (rare) "Habenero" finish, with a Rimfire technologies, Stage-One Bedding System.

Ruger 10/22 Reciever with Over size Pins and bolt buffer.
Bolt, Blue Printed trued and squared, head space set at .043, firing pin and extractor replaced with Kidd parts, firing pin drilled and pinned,
charging handle slot Chamfered for easier reassembly, bolt body ground and radiused and polished for easier cycling.
Bolt Handle, Rimfire Technologies Custom rod spring and handle.

Trigger Group, Hornet Custom, Red Baron Target, 2 1/2 lb. trigger, Auto bolt release, shimmed, red extended mag release and target trigger.

Barrel, Tach-Solutions 16.5 Custom aluminum barrel with a black 48 hole comp.

Scope Base, QualTac Reversible Picatinny Rail.
Rings, UTG - QDT/LEO, Color plating by Gun Candy.
Scope, Simmons 6.5X20X50, AO.

 

[BlkHawk73]

I can certainly concur with not being able to do just one. 15 or so thus far with 3 more in various stages and a few more in the planning book after that. I looked for quite a while for that stock in the green/black to no avail. Have done an orange one, or rather my son and I did. Never used a Tac-Sol barrel yet. Nice looking set-up.
What's next?

 

[T.A. WORKMAN]

What's next?

Working on two .17 Mach II's right now??
I have always enjoyed the ones you have posted on the forum.
Terry

 

[BlkHawk73]

Have made just one .17M2. Used an ER Shaw bbl and a MR bolt handle. It'll drive tacks. had an issue with the "first run" Hornady - split cases and a case rupture *ouch*. Have since gone to Rem/Eley or Eley and no issues. Eagerly await your next new. 8)

 

[Stoots]

Beautiful!