I have an un-fired round stuck in the chamber of my P95DC and couldn't get it out. Unfortunately I went to field strip strip it thinking I could get the slide off for better access to the round.
I removed the Mag and released the lever that folds forwards and down to allow stripping (part V00910). I then pulled the slide back and removed the slide release rod/lever (part V03713-10) and attempted to remove the slide, it would not travel more than a couple inches forward. I then moved the slide back and it locked into and will not move at all now.
I'm stuck.. Any suggestions?
https://www.dropbox.com/s/ii7h8li1wnuc4m8/Ruger%20P95DC.jpg
https://www.dropbox.com/s/hsz1ckk8hhwqj1l/Ruger%20Parts.jpg
I removed the Mag and released the lever that folds forwards and down to allow stripping (part V00910). I then pulled the slide back and removed the slide release rod/lever (part V03713-10) and attempted to remove the slide, it would not travel more than a couple inches forward. I then moved the slide back and it locked into and will not move at all now.
I'm stuck.. Any suggestions?
https://www.dropbox.com/s/ii7h8li1wnuc4m8/Ruger%20P95DC.jpg
https://www.dropbox.com/s/hsz1ckk8hhwqj1l/Ruger%20Parts.jpg