LC9 Trigger Short stroke?

[weemsf]

I have fired about 150 rounds through my LC9. On three of four occasions, the trigger dies not seem to go all the way through the firing cyle and them I have to retract the slide to reset the trigger. Anybody else having this issue or is it just my lousy trigger control?

 

[Egalloway]

Does it cycle fully? Eject and load fresh round? Are you allowing the hammer to reset by allowing the trigger to travel to the forward most click?
Eric G

 

[weemsf]

When the pistol fires, it functions 100%. The only thing I am experiencing is the rare time when the trigger seems to not go all the way through its pull, not fully cycling the hammer.

 

[Egalloway]

but your hearing/feeling two clicks in the trigger as you: release first click is the firing pin lifter arm reset. Click two is at front of travel as hammer resets to trigger bar.
Had some folks not reset the trigger when they test fired one of the LC9 pistols I have for testings.

 

[weemsf]

I will try to notice next time I fire it. It is my BUG and I need for it to be 100%. I figured it was operator error. I had been shooting a Sig with SRT kit installed so the triggers were vastly different. That is what I get for trying to shoot two different platforms at the same range session.