I'm a newbie and need some info re: sites I can send photos to that I can then retrieve and send to the forum. Anybody walk me through the process so a semi-PCilliterate can show some photos for critical review? Thanks in advance.
Need to tap through all 6. Looking for 'throats' not only smaller but 'different' or even out of round...
They are out of round and different. They vary by up to a thouandth in dia. & by .0005" in roundness. What should I expect?
I was able to tap a sized .452 bullet through and when miked the bullet measured .4515. I'll shoot it like that for now and see if it performs well as is before opening up the throats to the .4525 most shooters take them to. Now that I know the throats are not the .450 so many complain about I...
I think I've read some threads that refer to replacing the stock NM Blackhawk hammer with the Super Blackhawk model. Is it a drop in if true or is there a lot of fitting required? Is it worth it to have the wider hammer spur or are there other advantages?
I ordered a blued 5-1/2" NM Blackhawk in 45 Colt and it arrived at my dealer's shop last Friday. I can't pick it up until the 29th but I stopped in this morning to check it out before next Tues. I was very pleasantly surprised by the overall smoothness of the action and especially the trigger...
I am a newbie and have been enjoying the reading as I wait for the 10 day wait to expire on my 5-1/2" blued 45 Colt. I live in Calif. Not as bad as some states yet but well on it's way. I have read some threads about replacement cylinder pins, and other mods commonly made to these guns. Can...
In my .45 Colt Uberti, I find wheel weights just abourt ideal for 900-1000 fps. The good work that can be done with such a load is a wonder to behold, enough to make you wonder why so many people feel the need to abuse themselves with magnums. They certainly have their place, but the old , pokey...
I have seen a number of references to tight cylinder chambers on 45 Colt Blackhawks. What do I look for and under what conditions do I or should I ream them. I have seen a chucking reamer in .452 on Amazon.com for a bit over $20. Is that a good price?. It's new, not used.