Recent content by lbk

Got my P94 back from Ruger. They replaced the extractor, note says they put 40 round through and all was good. I ran a magazine of snap caps through using "sling shot" cycling....all went smoothly. Can't wait to do live rounds. So how does one address the challenges in getting these parts...

I had a chat with Ruger and decide to send them the P94....with no real source for replacement extractors I didn't want to mess with it myself. I will see what ultimately needs to be done to fix...will update the post.

Here are a couple of better pics. So the extractor tension feels tighter than on my other P94 (via pressure to move with my finger) . I did drop a note to Ruger to see what they have to say. You can't see it in the pics but opposite the extractor on the breech there is a small crescent cut-out...

OK so I made sure the extractor channel was clean (no dirt or residue found) and worked the extractor claw including bottom and edges with a bit of polish with the Dremel tool. Put it back together and still jams. I also have a P94 in 40 S&W and the tension on the extractor is not as stiff. It...

So far modrifle3's suggestion is the one that helps!! The jams started when I was into my second magazine (as noted magazines are new) and the pistol was spotless and properly lubed. I did a tear down and the bullets fed into the barrel smoothly. Slide worked w/o any binding. I pulled the...

Here is a pic, I'll do more and clearer when I clean it. The slide is pulled back and released quickly. http://postimg.org/image/vkaj26st1/

To clarify this is a P94 not a pc94...

I picked up what looked to be a hardly used PC94. Using new Ruger magazines, I have been getting jammed rounds. Mostly the first round but some subsequent. Sometimes when I push down on the top/back back of the barrel block it loads. Otherwise need to drop magazine and pull back slide to clear...

Sabby, Like your set up...who's scope base did you get? See a few out there but want quality. I picked up a Tru Glo Tru Brite Dual Color and want to keep it on tight and not have to remove rear factory sight. Thanks!!

Mr Mike, What distance do you shoot and still be relatively accurate with the 180 grain? Thanks

WAYNO & Randy M....much appreciate the feedback & advice. I suspect I'll try a few different types of sights/scopes. Once I get some ammo it is off to the range!! LBK

New to Ruger forum and I am looking for some advice. What 40 S&W should I try, not only manufacturer but also # grain?? Any of the re-manufactured ammo any good? Also, what works well as a scope, traditional, dot, tactical? I'll be primarily doing 50 yards at the range but will also do...