Help Support Ruger Forum:
-
-
JAs I understand it, the .30 Super Carry is the same length as a 9MM, so why doesn't Ruger produce an LC.30 SC? Or if they don't, is it...
-
Jjoecrab replied to the thread Lots of 480 Ruger Alaskans.I had an Alaskan and also a 7-1/2" Redhawk in 480 Ruger. After a couple of summers of load development and shooting them, I discovered...
-
Jjoecrab replied to the thread GP100 357 mag question on using hard cast lead bullets occasionally.Shooting cast bullets will not hurt the gun at all. Actually it is easier on the gun than jacketed bullets are. When shooting cast...
-
Jjoecrab replied to the thread .375 Revolver ctg?.I had a .300 Savage that I extended the neck on with a 30/06 reamer and then used government .308 brass run through the .300 Savage die...
-
Jjoecrab replied to the thread Another New 32 H&R.And that can cost you money. Having an extra cylinder eats on gun people until they figure out what to do with it. Hmmmmmm. :unsure:
-
Jjoecrab replied to the thread Another New 32 H&R.Maybe he just wanted an extra cylinder for some reason and decided not to go through with whatever he had in mind.
-
Jjoecrab replied to the thread Another New 32 H&R.
-
Jjoecrab replied to the thread Another New 32 H&R.That was the Blackhawk Buckeye Special. I had a Buckeye Sp. in 38/40 - 10MM. They made a 32Mg-32/20 and the afore mentioned 38/40-10MM
-
Jjoecrab replied to the thread Another New 32 H&R.If he was gonna do that, he would have a 32/20 fired brass with a step on it after firing. The .32 Mg. is just a tad larger in diameter...
-
Jjoecrab replied to the thread .375 Revolver ctg?.The more I dig into this, the more I am coming to the conclusion that if it ever happens, it will have to be done by people with...
-
Jjoecrab replied to the thread .375 Revolver ctg?.The .225 Winchester would be a good case to use cut back to 1.28" because it is a case developed for higher pressures and the rim is...
-
Jjoecrab replied to the thread Too Many 32's??.
-
Jjoecrab replied to the thread .375 Revolver ctg?.Well it's cold outside and over the years I have lost my apatite for bucking snow drifts and getting all bundled up. I can only watch...
-
Jjoecrab replied to the thread .375 Revolver ctg?.I don't think that one would work in a GP100 or a Blackhawk. I am not thinking about a super hi-powered cartridge, just something that...
-
Jjoecrab replied to the thread 44 SPL Vaquero frame size?.I think the .44 Sp. flat top is built on the smaller frame.
-
-
Loading…
-
Loading…
