Recent content by Deadeye

I have the Accusport Bisley Convertible. I sent the 45 Colt cylinder to Mr. Bowen to have the cylinder throats reamed to .4525. It made a big improvement with cast bullets. The accuracy now is great. I left the 45acp cylinder as is because I only shoot hardball thru it and it's accurate. The...

Good advise, I've had to do that on the pivot pin on a 45 Bisley and my GP100.

I just purchased a New Bisley Blackhawk 45LC with the extra 45ACP cylinder. The problem I believe is the cylinder gap which I measured at .009 compared to the gap of the Long Colt cylinder of .006 . I have 3 other Rugers GP100, LCR 38spl which both have cylinder gaps of .005 . The 3rd which...

A Model Single Nine 22mag.. It's my only Ruger 22 so I guess it will be my favorite...

I have the same problem with Starline brass in my GP100. I didn't experience this problem with a S&W 686 that I once owned.

It didn't change the impact at all. Of course I only shoot it at 7-10 yards. It vastly improved the sight picture for me..

1.610"

Charles, Don't be puzzled, The sight came pre drilled but the the hole didn't quite line up so I used the thumb drill just to align and cleanup the pre-drilled holes. If I didn't I would have certainly would have damaged the pin.

That's about what I had to do, I used a thumb drill number 53 to get it on and it certainly improves the sight picture. Thanks

I ordered a green Hi-viz sight for my LCR. Can I expect any problems installing it? Does anyone have any tips they could share? I have a fiber optic on my 1911 and it is very easy to see.

I loaded up a 30 rounds of 45ACP with .452 Falcon hard cast 230gr and Trail Boss powder and took them to the range yesterday to try them out. If you want a practice load with light recoil and accurate this is the way to go. I had 0 malfunctions, and it was a lot cleaner than my loads with HP38...

I had a set of Lee dies in 30-06 about 30 years ago. It would mark the cases with a scratch down the side of the case. I never complained to Lee and just went out and purchased RCBS dies. Since that time I have purchased Lee 4 die sets in 357 and 45 acp and have been very happy with them. I...

I thought I would share this with the group. I loaded some 357 Starline brass with 4.0grs of Trail Boss Powder topped with a 125gr. Falcon TCLP bullet. It's a very light recoiling load which has turned out to be the most accurate load to date in my GP100. Most know that Trail Boss is more...

I have 2 uniflows, one with the small cylinder and the other with the large. The smaller one I use for pistol loads 357 & 45acp the larger cylinder for Rifle such as 30-06.. I find the Uniflows to be very accurate without deviation with powders such as W231.

Thanks for the heads-up on the Lewis Lead Remover. I just ordered one from Brownells. Thanks again.. Deadeye :D