I tried to set up a mill to cut slots in my slide but the bit wore out too fast to finish and it turns out my drill press has a bad bearing so it is a little sloppy.
So after roughing the slots in the side of the slide I ended up going over them with files by hand to try and save the project from the trash. I couldn't believe the bit died so fast.
I also modded the decock levers and added a loaded chamber view port.
Hopefully my computer will allow me to download pictures tomorrow.
Until then.... teaser.
Keep the P-guns alive!!
So after roughing the slots in the side of the slide I ended up going over them with files by hand to try and save the project from the trash. I couldn't believe the bit died so fast.
I also modded the decock levers and added a loaded chamber view port.
Hopefully my computer will allow me to download pictures tomorrow.
Until then.... teaser.
Keep the P-guns alive!!