cpt-t
Single-Sixer
Hondo44 Thanks for the picture of the offending part, now I know what to look for. Don`t you know BILL RUGER was rolling over in his grave after His old company did this.
ken
ken
Ruger blackhawk internal lock
- Thread starter 338reddog
- Start date
Help Support Ruger Forum:
caryc
Hawkeye
cpt-t said:
The worst part if the lock was that you had to remove the grip panel to lock or unlock the lock. There is a dimple on the back of those plastic grips. It's there to mark a place for you to drill a hole in the grip panel so you can work the lock without removing the panel. Great idea huh ?????
BPGuy
Single-Sixer
Or, you could do what I did: Took the whole thing off an made it into a Bisley! 
needsmostuff
Blackhawk
My biggest beef with them is they actually stick out wider than the grip frame just a little. If you make a set of grips they have to be inlet around the silly lock.
That and it's just silly extra weight.
That and it's just silly extra weight.
caryc
Hawkeye
needsmostuff said:
When I was making grips I made a router jig to do those recesses.
