williamc
Single-Sixer
I've just purchased my setup to get into reloading (including a Lee Classic Turret press), and I'm going to build a corner workbench for my garage to attach it too. I figured I would use the unused corner of the bench to mount it, on a flat shown by the red line below (not to scale):
My question for you guys is how wide should I make that red segment? I was thinking 12", but I'm concerned about making it too narrow.
Thoughts?
I'd also like to hear if that position on the bench is inherently bad for reasons I may not be aware of. FYI, a vise is going on the downward facing leg at the end of the tabletop.
Thanks!
William
My question for you guys is how wide should I make that red segment? I was thinking 12", but I'm concerned about making it too narrow.
Thoughts?
I'd also like to hear if that position on the bench is inherently bad for reasons I may not be aware of. FYI, a vise is going on the downward facing leg at the end of the tabletop.
Thanks!
William