FS: Ruger OM 357 converted to 44spl.

[oldies]

FS: 44spl mid-frame 3 screw. Nice, tight and
accurate single action. Frame Has been Flat-topped
and still reads "357". Retains old model 4 click action.
Grips are from NM Flattop.
$750 shipped CONUS. Pvt. Pty. to your FFL.

 

[Hondo44]

Oldies,

Very, very nice! Looks like a factory gun which I very much prefer to a conversion with all kinds of bells and whistles stuck on it! The flat-topped frame is a great touch too!
Did you do the work or do you know who did the work?

Original barrel re-bored to 44 or a shortened 44 mag barrel?

Original 357 cylinder reamed to 44?

If I hadn't just done one, I'd grab it! But I'll pass the word in my circle of Ruger nuts.

 

[oldies]

Thanks,
Original barrel is a re-bore, cyl was done by Bob James of Phoenix.
I turned the barrel off and on again. cyl. was from same gun. I
flat-topped the gun myself. This was all about 10 years ago, so I don't
remember who did the barrel.
oldies