elk and damascus EDC (sold)

[tuskbuster]

nice little EDC from a billet of alabama damascus. 2 3/4 tip to plunge,3 cuttin edge,6 3/4 OAL ,nickle hardware ,filework rom butt to 1 in from tip. left or right hand 8,9 ounce leather sheath . all work done in my shop by my hands
160.00 shipped buyer was no show and need to sell some

andy [email protected]

 

[tuskbuster]

bump

 

[MikeJinVT]

I'll take it. PM to follow.

 

[tuskbuster]

sold to mike ,thanx

 

[pamtnman]

What's your Damascus mix?

 

[tuskbuster]

i buy my billets from http://www.alabamadamascussteel.com/servlet/Categories?category=Damascus+Billets%3ARandom+Pattern
then i design ,cut ,HT ,and finish my own blades.
thanx andy

 

[pamtnman]

i buy my billets from http://www.alabamadamascussteel.com/servlet/Categories?category=Damascus+Billets%3ARandom+Pattern
then i design ,cut ,HT ,and finish my own blades.
thanx andy

Thanks, Andy.
What's the RC you're getting after heat treat?
That's a great looking knife. You should be proud.
J

 

[tuskbuster]

my HT and temper at 375 for 2 ,2hr cycles should be around 58 to 60 rockwell , i do know they feel harder than the carbon blades i treat at same temps when i go to put final edge on now this is all i can wrangle out of my co mputer im just an old country boy makin em the way daddy taught me. my bigger knives i take alittle more of the backbone out of em