Custom pocket/IWB holsters for LCP and Max9.

[Hvymax]

Most pocket holsters don't seem to break up the outline of the pistol. So I figured that a spare mag would square up the whole thing and have a place for the mag. By adding a belt clip it'll work for IWB as well. A few post screws can take care of locating, retention and be adjusted

 

[Hvymax]

Coming along. About 1/4 of the way done.

 

[red Ranger]

Hvymax, did you do the tooling on the leather it looks good

 

[Hvymax]

Hvymax, did you do the tooling on the leather it looks good

Yes. That's just the swivel knife work. Next comes bevelling, shading, decorative cuts and veining. Then I can stain and wax stiffen before sewing everything up and finishing. If I'm going to make something I like something nobody else has.

 

[red Ranger]

Looking forward to seeing the results

 

[Hvymax]

One down.

 

[red Ranger]

Nice

 

[Hvymax]

I'm not 1/10 as good as I used to be. My saddle tan dried out and I need the finish as well so will need to wait till next week.

 

[red Ranger]

It looks good

 

[Hvymax]

I think the crappy dogwood flowers would look better as poinsettias.

 

[Hvymax]

Ready for a wax finish tomorrow. Not as bad as I thought they'd be. Tomorrow I'll stitch, sand and finish the edges and rub in some Carnauba wax.

 

[red Ranger]

Looking good

 

[Hvymax]

Looking good

Thanks. I decided to give it a first coat of wax. I also melt a thin layer of wax on the back of the leather face pieces to stiffen them it almost turns the leather into wood.

 

[Hvymax]

Ready to stitch!

 

[red Ranger]

It is nice it looks like a itw and Oreo like it