AR15 Trigger Adjusting Jig with Dry Fire Block

[Carry_Up]

I have an unused hammer/trigger adjustment jig made by Brownells that fits on the outside of the AR lower receiver. Special pins hold the hammer and trigger in place on a special bracket. Trigger/sear and disconnector engagements can be seen, adjusted and tested using this jig. A large block of delrin fits into the magazine well and serves as a dry fire block while adjusting the trigger.

$25.00 shipped
Carry_Up

The link showing the device is here: note the pins are for standard AR lowers. This will not fit onto a Colt lower with large .170" pins.

AR15 Trigger Jig