Recent content by wvrick

Same here, I'd go 357 Mag in 4" with ammo for a 44 Mag what it is. Plus the SS will last a life time.

After looking at the speedloader, I remembered the 44 Mag I had jiggled, and the 357 Mag don't. I seen that the clip the touches the base of the case pushes the round toward the center of the loader. When you put the loader in the cylinder the bullet go's on ok but it catches on the brass at the...

Contacted HKS today, very friendly and said to send them back and note any misalignment ( tilt in or out ) and they can use another loader parts to correct the problem.

Does Tuff Products Mfg. HKS? I never found HKS's number

GP100man - I've tryed 38 SPL=P 125 gr. GDHP Gold Dot, FIOCCHI 357 Mag. FMJTC 142 gr. and some hand loads with lead SWC. The 38 seam to load the best but still not like they should.

Well, I have tryed to get a phone number for them and their address comes up empty???? There is no number or any contact info of their web site either.

I have used them in the past in other revolvers brands in 44 mag and they worked great 15 years ago, since I bought my GP 100 I have got two model 586-A that are the model for my GP 100 and if I needed to reload with them I might as well do it by hard one at a time. I have to jiggle them and...

Thanks for the info!

I see I can buy the insert style grips and going to order them soon. What I'm needing to know is if I need to order the round pin that go's thru the frame also, my grips have the screw in the butt and not thru the middle of the grip. In the picture on rugers site, it shows my grips and the pin...

I'm not sure which fits the GP100 4", I'm thinking the size 2 model 8302-2 in LEFT hand, but not sure with their description. RE: "3 - 4" barrel medium and large and 6 - 7 1/2" barrel single action revolvers" http://www.uncle-mikes.com/products/sid ... sters.html Or does anyone else have a...