Recent content by Tx gun runner

I will take $50 shipped . The are not real stag ... PM me if your interested .

I will take $50 for these shipped . They are not real stag . PM me if your interested

I shot every kind pistol matches with wheel guns and bottom feeders since 1968 and was always one of the top shooter and held alot of club records . I been a gunsmith and built 90% of my match guns and I don't see or understand why a 10MM wheel gun is needed . When a box stock bottom feeded in...

I'm missed something . Why a 10MM revolver when there is 10MM bottom feeders for fast reloading , and 41 mag and 38-40 already in revolvers which will the same job and a bunch cheaper that a custom gun .

I love the 1911 and carried one from 1968 to 2003 , but I love my Glock better for a CCW since it was the 1st DA gun I could reach the trigger with my small hands and you can shoot 100,000 rds threw them without any problems , plus weight , size and trigger pull make it a super gun . I hate all...

I know everyone love the Ruger in 45 Colt with the Ruger only loads . I'm scared someone going to put a Ruger only loads in the wrong gun and get someone hurt . A 454 or 44 mag is a safer way and if you forget or lose ammo you replace it easy also ..........

You can get Cimarron "P" OR "P" jr with lighting grip . The whole gun is cheap and they shoot good

I had 2 and cut 1 down to 3.5 inches

Here mine . I'm thinking of putting up for sale ... any interest PM and it has the correct cylinder for .429 barrel and forcing cone cut to 11 degrees .

The last ones from the factory 58-xxxxx had the correct cylinders in them for the .429 barrel and the ones with the bad cylinders I send back and Ruger repair them FREE . I have four 44-40 that will all take .430 bullet now and they are super shooters .

If your going to turn one down put it in 3 steps .427/.429/.432 or .427/.429/.433 . You need a .429/.432 or .429/.433 .. If you don't have a lathe put the stem in a drill and use a file to turn one down .

If you have the wright stem and die setup correctly , you should be able to put bullet in case before putting it the seater die and not flare brass .

However, after reading up on the dies, measurements are as follows First step/Second step/Bullet sizes 44MP .427/.431 .428-.430 I will be loading .431 - .432 bullets So unless I'm missing something the M-die will not open up the case mouth enough...

I haven't shot a match since I moved to Tx going on 2 yrs . I missed you 2 time at Fredsricksburg and Ft Parker 8 months ago . I've never seen a pic of you to ID you and your not riding that girlly bike ..... I when to 10 matches here but don't shoot . The sun and Tx heat gets to me and around...