Recent content by tom548

Still have the one I built 30 years ago and shoot it regular. Have take many deer some out at 125 yards.

I had a cylinder for my OM BH done 30 years ago by a fella in Ca. If I remember right it was just under $100. to get the hole punched to 44 and sent back. It was called the 357/44Bobcat, and the smith that did the work was Bob Booth. His had a stright cylinder design and used a collar on the...

Got the brass,looks great, Thanks Tom

I have a 20 to 120 X 60mm with tripod and hard case. Has winchester name on it I believe it was built by Vanguard. Email sent.

I will take 49 lapua 7.62X39 $15.00 and 247 357 max R/P w/primer $72.00. tell me were to send and how much shipping is Tom [email protected]

Email sent on 9 MM cylinder. I will Take One.

How many and how much $$ for .357 max brass?

I have one off a NM 357 BH, not sure if they are the same . If it will work email me at [email protected]. It looks like new .

Thanks, Non of mine had that type of cylinder. I was also guessing colt cylinder Thanks Tom

I have a NM 9 mm cylinder total lenth 1.96" cylinder lenth 1.835" and the Dia. is 1.73" . Looks like it was never shot, but does have a very short and light turn line. If interested email is [email protected]

I stoped at a garage sale today and the guy had some rifles and some misc. Ruger Blackhawk parts. One was a cylinder .357 mag that he said came from a Blackhawk. It did look like a BH cylinder except the rim of the .357 case was counter sunk into the face of the cylinder and there was a 1/8" to...

Hill Send pic of the revolver [email protected] May be interested

My bad, just checked mine I was thinking of a 4.5

I believe the 5.5" usually ends near the ejector rod housing