Recent content by Stoneagle

The serial number on the box is the same as the one on the stainless frame. You're right, Chad has not been to town in a long time. I've been at this location in Newport for 28 years now and he has been in my shop. I have all the paperwork that you mention.

Are these mags the older, original style with chrome colored bottoms or the current issue ones with grey plastic?

Thanks, Gary. Check's in the mail, (I love to say that!)

This one is not matte, but verges on bright.

I have an unfired KM77RSI in .250 Savage. Model # is 17972. Serial number places it around 2009, and it's marked M77 MARK II. Anybody have any information on this? Was purchased at a gun show outside Washington in VA about that long ago. I figure it must be a distributor special. I have the...

Thanks Dan. Search is over.

It does not. There is a threaded hole only. Thanks for your response.

Looking for a steel ejector rod housing for an Old Model Blackhawk, .357 mag with 6-1/2" barrel. This is the protected sight model. Bluing should be in very good condition.

Because they only made 300 of them.

Has anyone seen any of the new Mark IV pistols yet?

Thanks for the "proof reading", Jim. And I read that post several times before pushing the button! The 68 comes from the employee who I got the piece from. I haven't seen the number in writing, so will not state it as gospel. One of my sons had an M77 MK II "stainless" several years ago that...

I understand that the two tone, (catalog no. KBN-3275A), was actually an error. There were supposedly 68 non stainless cylinders produced by mistake, and rather than scrap them they built them, gave them their own model no, (00356), and made them available to employees. Mine is as pictured...

I'll take #4, the 252, .22LR.

PM sent.

Got 'em, Buster. 5 for $10 with $5 shipping for as many as you'd like.