I have a new Redhawk 45 colt / 45 acp that is bone stock that is having light primer strikes in DA mode. I know Ruger will fix it but it is frustrating because the last gun I bought just a couple months before this was an sp101 match champion that had to go back to Ruger, could not be fixed...
Gramps,
As frankenfab posted earlier in the thread here is the link to lipseys showing what it is:
https://www.lipseys.com/itemfinder.aspx?mfg=Ruger&type=Revolver&caliber=327+Federal+Magnum
I know this is an old post but I just wanted to say THANK YOU to wixedmords for the suggestion to shave down the shell holder did the trick!!
I have used these same dies to load for a Contender with no problems but the Mini-14 I just got was pickier about the shoulder set back and wouldn't go...
Fellers just so you know Fireball is well known on the SASS wire and is good to go.
I can't afford these myself but Fireball is a man you can trust.
Vaya Con Dios,
larrupin
Just called and ordered from Mike last Tuesday or Wednesday.
My dealer called me today and I picked it up.
Great little gun, I love it!
Mike was great to work with and PROMPT! I wasn't expecting to get it this quickly. No surprise to those on the forums but ACRYLICTNK is great to do...
Good info!
Hey Contender , where do you buy your plated bullets.
I used to have a source years ago for plated bullets but they went belly up.
Thanks again folks,
Larrupin
PS, none of my 9mm's are Glocks so I am good with cast
Thanks for the reply!
It is interesting that you recommended HP38 because I just got back from the range and shooting 25 rds of some 115 gr JHP over 5.0 grains of HP38.
I only loaded 25 rds to see how they did, shot very well, accurate and clean I was pleased and will definitely work more...
Howdy!
I have been reloading revolver and rifle cartridges for 25 years but just have not fiddled much at all with semi-auto catridges, and since I used to be able to pick up 9mm at WM cheap I just didn't take the time to mess with it. But with prices going up and supply hit and miss I decided...