Hondo44
I have a M30 S&W just like yours which I purchased with the intent to add target sights as you have.
I don't have machining capabilities, only hand work abilities so have not started the project.
I might be able to fabricate a front sight but machining the groove for the rear, I think...
Jim,
My trigger overtravel stop is really just an extension on the trigger return plunger...seems to work ok.
What is the trigger second from left in your pic, a standard NM?...I've never had a NM so am not familar with them.
You mentioned that you intend to perform a final profiling on the...
Jim,
Thanks for the response. I didn't realize you used a NM .32 cylinder in your conversion. Alan did indeed use the original OM cylinder I supplied for my conversion and like you said, by the time he removed the recess the O.A.L. was reduced creating the condition I described. I'm working...
There is some good information on the Beartooth Bullets Forum about the .327 Federal...
http://www.shootersforum.com/handgun-cartridges/47667-327-federal-thread.html
Hondo44
I'm curious to know what the length of your cylinder ended up being after the conversion. You mention that you intend to ream it for the .327 Federal.
I have a OM Single Six converted to .32 H&R by Alan Harton that has a cylinder length of 1.344", I think this is correct, I'm not where...
I have a 71/2 year old male brittany that I use for bobwhite hunting here in NW Florida. He doubles as companion/pet and is part of the family (me).
As a puppy, I just took him to the woods as often as I could...his breeding kicked in and he has turned out to be a real gun dog. I suspect that...
Here is a link from the cast boolit forum about this subject that may be of interest. The author helped me make the required tools to make the capsules for .32 S&W long and .32 H&R. It's a little involved, but it is a way to increase the shot load...
Mention was made to blued hardware for handgun grips.
Does anyone know where this can be obtained?
I'm getting ready to make a set of grips from some Holly and want to use blued in lieu of stainless/brass.
I want to view a picture of a SP101 with the partial underlug that some of the .22's came with. I've been searching the back posts but so far have come up short. Can anyone point me in the right direction? I know I've seen one somewhere in the past, but it has eluded me so far.
Thanks
Anyone have a current Email address for Mr. Harton?
I've tried to contact him at [email protected] but not recieved a response...been three or four days. He may just be busy or the address may not be current.