Recent content by Conman

Be careful, very careful. I started with one and now am up to 29 with one more on the way. Be careful!!

Welcome from IOWA

I have one of these due in sometime soon. Before the magazine versions. I will post photos sometime next week.

I have reached the old age where I must carry "stuff". I finally settled on this Across the Chest bag. It goes over the left shoulder and under the right armpit. It holds all the junk I need and there is a middle pocket than very handedly holds my Colt 380 with extra magazine. Right in the...

Those were special rifles put out by TALO and only approximately 3,000 of each were made.

IT is a 1970 1st version Bearcat. Too much trouble; I’ll live with it! Thanks for input.

Sorry I didn’t cover all details. I tried different brands of ammo. I used a mild compound with a mop. No change. That is why I asked about specific compound to relieve the tightness. OR should I just learn to live with three tight holes??

Yesterday afternoon my new to me Bearcat and I stepped out back to test fire. Three holes the cartridges dropped in and three holes took a push of a finger to load. What grinding compound would be best to use on the tight cylinder holes?? I have already cleaned them all well with a brass brush...

Linn County

My only concern was I didn't understand all I read. Originals were plastic checkered; then walnut plain; then the Ruger inlays, etc. Looks like the ones on mine are correct. I like them. Thanks.

Most military members move a lot. Me, not so much. I did 5 years in the Pentagon and over 10 in Sunnyvale, CA. A buddy of mine went to SEA 3 times and stopped to spend the night with me in Sunnyvale going and coming. Poor guy. I did have to leave once to spend a year at U-Tapao, Thailand...

I went to my gunsmith Saturday to pick up my 1906 slide action. Of course, I had to look in the glass case. There lay a Bearcat. I did not own one; now I do. The only one I had ever seen was one a friend of mine bought for his wife in France back in 1959. Therefore, I am totally ignorant of...