Recent content by Bllade

One time bump

I have a complete Dillon Caliber change kit for a 550 progressive loader with 18# of cleaned .40 brass. The Dies and powder drop have approx 140 rounds through them. the brass is mixed headstamp and totals about 1800 rounds. Ammo case does not go with the brass. I'd like $340 + shipping for all.

Thanks Guys, I reinstalled the factory mainspring last night and left in the latch spring. I do not notice much any difference in the trigger but hopefully it will correct the FTF. I'll find out at the range later this week. Trigger return seems fine so I am going to leave the latch spring as is...

Ok guys, please remember that I'm new to revolvers and especially the SRH I purchased used since I know this may be a very basic question. The PO had Wolff springs installed. The trigger Guard latch Spring was replaced with a Wolff 10# spring and the Hammer Spring was replaced with a 9# spring...

Thanks for the replies and links Guys... I've been through most of the powder co links and one thing I have noticed is that they do not cover all of the possibilities of different bullets that are available, nor would I expect them to. Unfortunately I have not found one for the OT 250gr RNFP. I...

Sorry. I guess I could have added the important information. I've got two bullets I am going to try, one is a Hornady XTP JHP at 300 gr, the other is an Oregon Trail cast bullet, flat nose at 250 gr. I was going to load the XTP's today with 21 grains of 296 for a velocity of 1250fps. I am trying...

I just started reloading in the 454 & 45 colt calibers. I loaded up 100 rounds of 454 with new starline brass without any issues. Today I was setting up to reload 45 Colt brass. This brass is once fired and was initially shot by mine in the pistol it will go back into. Since getting into the big...

I ended up ordering some 250gr cast bullets from Oregon Trail and some 300gr Hornady XTP's. I have 296 in the shop but need to double check the books for something lighter to start with. I've been doing a lot of reading about casting my own bullets and it is something I would like to try. I...

Hi everyone. I've been reading through a lot of previous posts and have not found ll the information that I am looking for. I just added a SRH 454\45 to my collection and need some help with loads for it. I've been reloading metallic for quite a long time but this is my first large bore hand...