The process of adding a RW grip frame to a Ruger

[contender]

I would think that a skilled person on a lathe could do this.
I too found that my set needed a relief on the edge of the shanks to prevent them from rubbing the frame. A little bit more of a shank would be easy.

 

[tbobcar]

If there is a need in the community I would tool up to turn a few on my lathe for consumption.

 

[Bigbore5]

I'd like a set

 

[tbobcar]

Sure thing, but don't wait on me. I'll see if any local smiths want the little fixtures, then I'll tool up.

 

[tbobcar]

Reminds me of 45 years ago making an 1858 Remington from rough castings.

A simple Bridgeport or CNC?

 

[Hvymax]

A simple Bridgeport or CNC?

I was 15. Files and sandpaper.

 

[tbobcar]

Ah, a true craftsman.

 

[wproct]

I have enjoyed this thread. I purchased a stainless steel grip frame from Brownell's for my blued steel Single-six revolver just because I like a two-tone look. Properly fitting the new grip frame takes more patience and skill than one might think. I have gotten mine close but not perfect. I'm to that point where I have to constantly be aware that excess metal can always be removed but can't be added back.

 

[contender]

My part in fitting the g/f & making grips has been delayed due to deer season. But I will be doing it as soon as I can.