P89DC,
Hondo44 said:
What calibers are the Bisleys blocking the trigger and which do not?
P89DC said:
I thought it was just trigger creep, all of my Ruger Blackhawk/SBHs do that (creep ~1/4" before releasing the hammer). Is this how to detect if the transfer bar is being pinched?
Once the hammer is cocked, a 1/4" of creep is unheard of in a Ruger single action.
IF TRIGGER DOESN"T RETURN, Transfer bar is pinched:
If the transfer bar is hanging up under the hammer face, since it's connected to the trigger, it prevents the trigger from returning. The transfer bar is slightly too thick. If both ends of the trigger return spring are connected (under the grips), or even if you have only one leg of the spring connected it should pull down the transfer bar if it's the correct thickness. When this happens, the transfer bar safety function will not work. If the gun were dropped, a live round in the chamber under the hammer will fire.
TO TEST HAMMER/TRANSFER BAR FOR MISS-FIRES:
With hammer fully cocked, press on the transfer bar to extend the firing pin and observe how far thru the recoil shield it protrudes. Now keep the trigger pulled back, drop the hammer and observe the firing pin again. If firing pin protrudes the same amount, you're good to go. If it doesn't protrude the same amount, you need to remove just enough metal from the top face of the hammer nose so the transfer bar is pushed tight against the firing pin and the frame. If you remove too much, the transfer bar will not perform its safety function and will be pinched. Also make sure hammer has no friction or contact with grip frame ears around its base to slow its fall and you may have miss-fires; another potential issue when making hammer changes.
This is not uncommon however, and it's a very simple fix. File the second step of the hammer face, counting from the top, just a bit until the bar no longer hangs up. Don't take too much off or you'll have miss-fires. If that happens file a little more off the top step of the hammer.
TO TEST AT THE RANGE:
Double check the safety function by loading a live round in the next chamber to cycle under the hammer, point down range, cock the hammer, hold with thumb, release the trigger to uncock the hammer, take finger off trigger and release your thumb to let the hammer fall. The round will not fire if safety transfer bar is functioning correctly.