I made some a while back to see if there was any "REAL" interest.
A little, but not enough to make it worth one's time.
Everybody that replied to my post... I offered to send them one for free, just needed a address.
Out of 15 only 4 PM'd me a address.... go figure.
Edit to add original thread;
http://www.rugerforum.com/phpBB/viewtopic.php?t=70714&highlight=prop
And sorry I think these look way better than the Plastic & Paint.
3/4" dowel, Dark Wood was Walnut, Lighter wood was Cherry.
The Medallions cost $2.50ea, the Dowel was ~$2 ea, a little epoxy, satin, sandpaper & scotchbrite.
I'm sure one could buy the wood for less in quanity.
I cut them just under 5" getting 6 out of a 30" dowel. (~$12)
The Walnut/ Cherry does look good but don't know if I would spend the extra $$,,, would probably just go w/ a hardwood dowel (~$4) and stain it dark next time, after all, it's just a stick. :roll: